A Note About Line Width

Any line widths in this guide are expressed as a percentage of nozzle diameter.
This allows the guide to remain agnostic to nozzles.

SuperSlicer natively allows percentages to be entered this way.

However:

  • Prusa Slicer bases percentages on layer heights instead.
  • Cura does not allow percentages at all.
  • Other slicers may or may not support this.

:warning: For Cura / Prusa Slicer / possibly others, you MUST use static line widths.
For example, enter 0.48mm instead of 120% if you are using a 0.4mm nozzle.