Skip to main content
Link
Menu
Expand
(external link)
Document
Search
Copy
Copied
Ellis' Print Tuning Guide
Welcome!
Before We Begin
A Note About Line Width
Setting Expectations
Voron V2 Gantry Squaring
Tuning
Extruder Calibration
Build Surface Preparation & Handling
First Layer Squish
Pressure Advance / Linear Advance
Introduction
Pattern Method
Tower Method
Lines Method (DEPRECATED)
Saving Your Value
Extrusion Multiplier
PA / EM Oddities
Cooling and Layer Times
Retraction
Infill/Perimeter Overlap
Stepover
Advanced Tuning
Determining Maximum Volumetric Flow Rate
Determining Motor Currents
Determining Maximum Speeds and Accelerations
Misc. Guides
Controlling Temperature G-Code Order
Passing Slicer Variables to a Macro
Useful Macros
Beeper
Conditional Homing
Conditional QGL
Dump Variables
Get Variable
Hotend Fan RPM Monitoring
LCD RGB
Off
Parking
Pause/Resume, Filament Swaps & Sensors
Replace M109/M190 With TEMPERATURE_WAIT
Shut Down Host
TEST_SPEED
Troubleshooting
Build Surface Adhesion
Bulging
Crimps
Extruder Skipping
Extrusion Patterns / "Wood Grain"
First Layer Inconsistencies
Thermal Drift
First Layer Inconsistency
Z Offset Inconsistency
Layer Shifting
PLA is Overheating
Perimeter Separation
Pockmarks
Slicer is Putting Heating G-codes in the Wrong Place/Order
Small Infill Areas Look Overextruded
VFAs (Vertical Fine Artifacts)
Misconceptions & Bad Advice
My SuperSlicer Profiles
My Setup
Issues, Feedback, & Contributions
My SuperSlicer profiles are located
here
.
here.